peny pinch evap system

[adamsvega]

k guys the elcheapo solution to vapors and moisture and minor leaks is here . seams the old check valves in the collector dont draw with exhaust on ....and a pcv is just asking for trouble.
i stacked three ebay 1.5" brush-less computer fans on the back of a mopar evap filter. and plumbed that off the vent of a small 1qt. puke tank to the old valve cover breathers with no other vent .it keeps around a 2" vacuum at 1500 idle. wired it to a after run relay to stay on 15 min. after shut down ....... can is collecting well,inside covers are clean and it evaporates out total cost if new is about 40$ time to ebay
the next test is bilge vapor fan with 50 more cfm than the lil computer fans stand by

[F/C-pilot]

Adam, I have an electric air pump used on new GM vehicles that I use on the dyno. It pulls around 5" at idle and keeps things nice and clean. I got it off of Ebay for $40 and came up with my own mount to hold it. I had one motor go bad and replaced it with another for $35. Anyway, just an option I ran across a few years ago.

Paul

[adamsvega]

THIS 4" IS 240 CFM... NEXT TEST SOON

[F/C-pilot]

Keep us posted as I always love to save a buck.

Paul

[adamsvega]

bump to get spam off front page

[car601]

Adam I know this is an old thread, but did you ever try it out?

[adamsvega]

yes it gets rid of moisture on warm up and shut down . not strong enough to pull ring seal but works good.
dont get a cheap ebay one ...go to a boat store and get a warranty

[triplenickel]

Hey 427sbc, here's a thread that you might be interested in!

[butterbean]

Adam done this to one of thier car'a and it worked well,